Seachem Reef Iodide 250ml (SC-556)

Seachem Reef Iodide 250ml (SC-556)

Iodide exists in natural sea water and is essential for the growth of invertebrates and many soft corals (gorgonians, sarcophytons, etc). Seachem Reef Iodide helps to restore the iodide levels in reef aquarium water to a level close to natural sea water.

Seachem Reef Iodide is a concentrated (8,000 mg/L) stabilised potassium iodide source. Stable iodide does not convert to toxic iodine under storage or reef conditions, hence is safe for dosing reef system.

Seachem Reef Iodide vs Others

Most iodine supplements on the market are simply potassium iodide or a medicinal disinfectant commonly known as Lugols Solution. Lugols is a highly concentrated iodine/iodide solution that is highly toxic and intended for disinfection. Although such products may be sold for use in reef aquaria, they pose a risk to reef in case of overdose or change in the product properties.

Seachem Reef Iodide is formulated to provide a safe source of iodide that will not convert to toxic free iodine under storage or reef conditions.

On the other hand, pure potassium iodide products are a safer alternative but not very effective alone owing to the unstable nature of iodide in the aquarium environment. When added to an aquarium environment, iodide becomes unstable converting to elemental iodine (which is biocidal), iodate (which is useless to corals, toxic at elevated levels, and cannot be tested for), and iodide which is the only form of iodine available to corals for uptake. Such products are inherently unstable, hence are potentially dangerous to coral health.

Unlike pure potassium iodide products, Seachem Reef Iodide is a proprietary compound that ensures iodide remains in its iodide form when added to the aquarium.

Seachem Reef Iodide also remains usable and fully bio-available after being added to reef systems. This ensures that your invertebrates and soft corals derive the maximum benefit from the product.

Ingredients

Ingredients: potassium iodide

Amounts per 1 g: Iodide (I) (min) 8 mg

Directions

• Beginner: Add 5 ml (1 capful) for each 200 L (US 50 gallons) every other day.
• Advanced: Add 1 ml for each 80 L (20 US gallons) daily to raise iodide by 0.10mg/L. If necessary, adjust amount so that iodide reads 0.060.08 mg/L 612 hours after the last amount. Thereafter, use this amount daily and check iodide twice a month.
• Expert: After determining the iodide consumption rate, set up a continuous drip system. Use the following formula (or skip the math and use our Dosage Calculator) to determine how much to add to your top-off water: m=0.125vi (m=ml of product to add to top off water, v=volume of tank in liters, i=amount to raise iodide in mg/L). For example, if you want to raise iodide by 0.10mg/L in a 200 liter tank, then you would add 0.125x200x0.10=2.5 ml into the top-off water. [For reference: 1 gallon=3.8 L].
• Notes: It is normal for iodide levels to decline after a few days. This results from utilization and chemical depletion. Therefore, amount and/or frequency of use can be varied. Amount used can be adjusted based on coral response. To check iodide levels use Seachems MultiTest Iodine and Iodide test kit.